Quick answer
To repair a foundation crack with carbon fibre, assess whether the crack is stable or active, inject it with resin through surface ports to stop water, then stitch it with carbon fibre staples or reinforce the wall with CFRP laminate strips. Bowing or displaced walls should be assessed by a structural engineer.
Foundation cracks are one of the most common calls a waterproofing contractor gets. Carbon fibre reinforcement, combined with crack injection, gives contractors a clean, low-profile way to seal and stabilize cracked concrete walls from the inside without excavation.
Why Carbon Fibre?
Carbon fibre has a very high tensile strength for its weight. Bonded to concrete with a structural adhesive, it helps hold a crack together and resists further movement. It is thin, so it can sit behind finished walls, and it does not rust or corrode.
Step 1: Assess the Crack
- Hairline or shrinkage cracks that are leaking but not moving are usually good candidates for injection alone.
- Wider or active cracks often benefit from injection plus carbon fibre stitching across the crack.
- Bowing, bulging or significantly displaced walls may need wall reinforcement and should be assessed by a structural engineer before repair.
Step 2: Inject the Crack
Crack injection fills the crack through its full depth and stops water from passing through. The typical process is:
- Clean the crack and the surrounding surface.
- Install injection ports along the crack.
- Seal the surface of the crack with a paste or cap seal.
- Inject resin from the bottom port upward until it flows from the next port.
- Remove the ports and finish the surface once the resin has cured.
Our Rhino Carbon Fibre crack injection kits are available in 10' and 30' sizes, along with dual-cartridge injection resin for larger jobs.
Step 3: Reinforce with Carbon Fibre
Crack lock staples (stitches) are installed across the crack at regular intervals. Each one is set into a slot cut across the crack and bonded in place, stitching the two sides of the wall together.
Corner repair kits are designed for the common diagonal crack that runs from a wall corner, using bidirectional carbon fibre to reinforce the corner.
CFRP laminate strips are used where a wall needs more reinforcement along its height. Follow engineering guidance for spacing and anchoring.
Best Practices
- Always follow the manufacturer's surface preparation, mixing and cure-time instructions.
- Work within the recommended temperature range; cold basements can slow resin cure.
- Document the crack before and after repair with photos and measurements for your customer and warranty records.
- Fix the cause where you can: poor grading, blocked drainage and hydrostatic pressure all contribute to new cracking.
Browse our full range of foundation repair products, including Rhino Carbon Fibre kits, injection resin and CFRP laminate.
Get the Right Products for Your Next Job
Whether you are pricing a full project or restocking your trailer, our team can help you choose the right products and confirm availability and shipping across Canada. Request a quote or contact us, or browse the full catalogue.
BASIS Waterproofing Supplies
Professional waterproofing, drainage, sump pump and crawlspace products for contractors across Canada.